Grain-systems Bin Accessories PNEG-248 Bedienungsanleitung PDF herunterladen

Date: 05-29-08 PNEG-248

Instructions

1004 East Illinois Street • Assumption, IL 62510 • 217-226-4421

PNEG-248

Printed in the U.S.A.

www.gsiag.com

Page 1 of 2

Wire Grill Guard Roof Vent

Wire Grill Guard Roof Vent Assembly and Installation Instructions

The following instructions are for assembling and installing the wire grill guard roof vent. Before beginning

assembly, check the packing list to ensure all components have been received. The unit is easiest

assembled in the upside down position as shown in Figure 1. Locate the roof vent as shown in Figure 5.

Assembly

1. Turn one (1) roof vent housing (MIS-6778) upside down. (See Figure 1.)

2. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the hole in the side of the roof vent. Place

jamb nut onto the bolt and tighten. (See Figure 1.)

3. Slide one eyelet of grill guard onto the 5/16" bin bolt.

4. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the other side of the roof vent, through

jamb nut and other eyelet of grill guard. Tighten nut against vent housing side.

5. Apply a bead of tube caulking around the three (3) housing sides of the roof vent where it meets the

hold down angle.

6. Place hold down angle (MIS-4404) on the assembled roof vent. The wide end of the hold down angle

must face the vent discharge. Once aligned, screw nine (9) #10 self drilling (S-280) screws through

the roof housing and into the hold down angle. (See Figure 2.)

Figure 1 Figure 2

1 2

Page 2 of 2 PNEG-248Wire Grill Guard Roof VentInstallation7. If the roof sheet does not have a prepunched hole for the roof vent, a hole must be cut.

Keine Kommentare

Grain-systems Bin Accessories PNEG-248 Bedienungsanleitung